Title: Das Futterhaus [Bird feeder hut]
Designer: Reinhard Fabisch
Model: 3 model sheets plus 3 pages with title and instructions
Built size: 6 x 6 x 15 cm (if printed on A4)
Number of parts: 38
Printing: We recommend to print the sheets on paper of 3 different weights (120 to 200 g/m2), according to the instructions on each sheet.
Complete model including instructions, PDF file, approx. 17 MB
Model and photos on this page by Reinhard Fabisch
- Assemble this inventive model according to the illustrations in the instruction. All parts are labeled so that you can locate them easily on the corresponding sketches.
- For a higher stability of the base we recommend to use wire for the sticks that make up the post and inner struts. Bring them up to the specified thickness by wrapping the wire with paper as shown.
- The white body of the house is printed twice on the same sheet - should a mishap occur when cutting out the many small windows, you can use the reserve copy to try again immediately.